| About |
|---|
| 环保和无毒，优良的热稳定性，阻燃，低气味 |
| Product Description | |
|---|---|
| Supplier | Kingfa |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Flame Characteristics,Low odor,Heat Stabilized |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 15 seconds | 81 | A 级 | ASTM D2240 |
| tensile strength | |||
| 50 mm/min | 16.9 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 50 mm/min | 286 | % | ASTM D638 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Retention of tensile strength | |||
| 50mm/min | 88 | % | ASTM D638 |
| Retention of tensile elongation | |||
| 50mm/min | 68 | % | ASTM D638 |
| other | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 20 ℃ | 1.0X10E13 | ohms·cm | ASTM D257 |
| Flame retardant level | |||
| 1.50-3.00 mm | V-0 | UL 94 | |
| Congo Red, 200 ℃ | 65 | min | GB/T 2917 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.35 | g/cm³ | ASTM D792 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | —40 | ℃ | GB/T 5470 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Melt temperature | 150-170 | °C | |
| Temperature of the rear section of the barrel | 150-170 | °C | |
| Temperature in the middle section of the barrel | 160-180 | °C | |
| Temperature of the front section of the material barrel | 165-185 | °C | |
| Mold temperature | 175-185 | °C | |
| Upper limit of processing temperature | 200 | °C | |
| Pre-drying | 60-80°C，2h | ||
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |