| About |
|---|
| MP300JA is a polyethylene based adhesive polymer containing anhydride functionality. This grade is for powder coating of steel pipe, so it is powdered in disk type grinder. MP30JA has high physical properties originated from MDPE and shows excellent adhesion strength and processibility. * powder type, color of pellet : gray&& |
| Product Description | |
|---|---|
| Supplier | HYUNDAI EP |
| Generic | PE |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.928 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 7.5 | g/10min | ASTM D1238 |
| Water absorption rate | |||
| 24hr | < 0.010 | % | ASTM D570 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -70.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 105 | ℃ | ASTM D1525 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Adhesive strength | > 2.0 | kN/m | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 49 | ASTM D2240 | |
| tensile strength | |||
| fracture | 15.2 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 650 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Powder |
| 3. Powder, D(v, 0.5) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |