| About |
|---|
| This data sheet describes TEKNILID WPSPPE product This lid stock is made with a Polyolefin (PO) heat seal (HS) material for Food, Pharmaceutical, and Cosmetic applications requiring a peelable bond to PE, COC, and PP along with high oxygen and moisture barrier performance You peel the foil back to expose the product This material has excellent puncture and chemical resistance It is available with custom and standard printing. A bright white exterior provided by Polyesterl white Polyethylene (W PE) outer layers makes an excellent printing surface for water based inks&& |
| Product Description | |
|---|---|
| Generic | 铝箔 |
| Material Status | Commercial: Active |
| Features | Good Printability,Low odor,Food contact compliance,Moisture resistance,Solvent resistance,Puncture Resistant |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| film | Nominal value | Unit | Test method |
| film thickness | 130 | µm | |
| Sealing emphasis | |||
| — | 0.44 | N/mm | |
| — | 0.63 | N/mm | |
| — | 0.63 | N/mm | |
| Oxygen transfer rate | |||
| 23℃，100% RH | 0.0 | cm³/m²/24 hr | |
| Water vapor transmittance | |||
| 38℃，90% RH | 0.0 | g/m²/24 hr | |
| dosage | 5.59 | m²/kg | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Thickness tolerance: ±10% |
| 3. To COC @ 350°F, 40psi, 0.5 sec |
| 4. To PP @ 350°F, 40psi, 0.5 sec |
| 5. To PE @ 350°F, 40psi, 0.5 sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |