| About |
|---|
| GLS 466-007B is an ultra-soft TPE designed for the applications where certain clarity and an extremely soft feel are desired. Tactile Feel Ultra-Soft Translucent&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Soft |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 10 seconds | 3 | ASTM D2240 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D412 | ||
| Fracture, 23 ℃ | 2.07 | MPa | ASTM D412 |
| 100% strain, 23 ℃ | 0.103 | MPa | |
| 300%应变, 23°C 3 | 0.241 | MPa | |
| Tensile strain | |||
| Fracture, 23 ℃ | 1100 | % | ASTM D412 |
| tear strength | 8.76 | kN/m | ASTM D624 |
| Compression deformation | |||
| 23℃，22 hr | 23 | % | ASTM D395B |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 0.868 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 3.6 to 4.0 | % | ASTM D955 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 2.20 | Pa·s | ASTM D3835 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 116 to 149 | °C | |
| Barrel middle temperature | 138 to 182 | °C | |
| Barrel front temperature | 154 to 188 | °C | |
| Nozzle temperature | 160 to 193 | °C | |
| Mold temperature | 12.8 to 32.2 | °C | |
| Back pressure | 0.00 to 0.552 | MPa | |
| Screw speed | 15 to 75 | rpm | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |