| About |
|---|
| SCLAIR® 2710 is a High Density Polyethylene material. It is available in North America for injection molding. Important attributes of SCLAIR® 2710 are: Antioxidant Food Contact Acceptable Good Aesthetics Good Processability High ESCR (Stress Crack Resistant) Typical applications include: Caps/Lids/Closures Consumer Goods Containers Food Contact Applications Household Applications&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Low density |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.951 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 17 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 100% non-ionic detergent, F50 | < 10.0 | hr | ASTM D1693A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 62 | ASTM D2240 | |
| tensile strength | |||
| yield | 23.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 530 | % | ASTM D638 |
| Bending modulus | 1000 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 120 | ℃ | ASTM D1525 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |