TECHNYL® C 236SI V30 NATURAL

About
TECHNYL® C 236SI V30 Natural is a polyamide 6 reinforced with 30% of glass fiber, with improved impact resistance, for injection moulding. This grade offers high impact strength and good mechanical properties.&&

Product Description
Supplier	DOMO
Generic	PA6
Material Status	Commercial: Negative
Features	Good liquidity,Good stripping performance,High impact resistance
Availabilitys	Africa & Middle East ,Europe
Process Methods	Injection Molding

Technical Data

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.080	%
Temperature at the rear of the barrel	250 to 270	°C
Temperature in the middle of the barrel	260 to 280	°C
Front temperature of material barrel	260 to 290	°C
Mold temperature	70 to 90	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.