| About |
|---|
| This data sheet describes TEKN|FLEX® VPOA 10200 ALU product Tekni-Films offers a wide range of PVC / PE.EVOH.PE/PCTFE – based film structures to meet both performance and cost requirements of blister packaging of tablets, capsules, lozenges, and suppositories&& |
| Product Description | |
|---|---|
| Generic | PVC+PE+EVOH+PE+PCTFE膜 |
| Material Status | Commercial: Active |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.36 | g/cm³ | |
| dimensional stability | |||
| 140℃ | -4.0 to 4.0 | % | |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | 375 | µm | |
| tensile strength | |||
| MD, yield | 37.9 | MPa | |
| Oxygen transfer rate | |||
| 23℃，100% RH | 0.47 | cm³/m²/24 hr | |
| Water vapor transmittance | |||
| 38℃，90% RH | 0.11 | g/m²/24 hr | |
| dosage | 1.96 | m²/kg |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Roll Width | < 106.70 | cm | |
| Temperature of hot forming mold | 100 to 160 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 30 minutes |
| 3. Thickness tolerance: ±10% |
| 4. Roll width tolerance: ±1.5 mm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |