| About |
|---|
| Easy flowing Injection moulding grade, low compression set, high abrasion resistance&& |
| Product Description | |
|---|---|
| Generic | PP+EPDM |
| Material Status | Commercial: Active |
| Features | Good Dimensional Stability,Good liquidity,Good wear resistance |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.950 | g/cm³ | DIN 53505 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 75 | DIN 53505 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Flow rate, yield | 8.00 | MPa | DIN 53505 |
| Tensile strain | |||
| Flow rate, fracture | 450 | % | DIN 53505 |
| tear strength | |||
| MD | 35 | kN/m | DIN 53505 |
| Compression deformation | |||
| 70℃，24 hr | 37 | % | DIN 53505 |
| 100℃，24 hr | 41 | % | ISO 815 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |