| About |
|---|
| Thermoplastic elastomer compound based on SEBS; injection moulding grade, for ABS and ABS/PC overmolding Overmoulding capability: ABS, ABS/PC&& |
| Product Description | |
|---|---|
| Generic | SEBS |
| Material Status | Commercial: Active |
| Features | Block Copolymer |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.12 | g/cm³ | DIN 53479 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 60 | DIN 53505 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| TD, yield | 4.00 | MPa | |
| MD, yield | 5.00 | MPa | |
| Tensile strain | |||
| TD, fracture | 350 | % | |
| Flow rate, fracture | 450 | % | |
| Compression deformation | |||
| 23℃，72 hr | 22 | % | DIN 53515 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 230 to 250 | °C | |
| Mold temperature | 30 to 50 | °C | |
| Injection speed | 快速 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |