Pro-fax 6331 - SOLIAO

About
Pro-fax 6331 Pro-fax 6331 general purpose polypropylene homopolymer is available in pellet form. This resin is typically used in injection molding applications. For regulatory compliance information see Pro-fax 6331 Product Stewardship Bulletin (PSB).&&Pro-fax 6331 Profax 6331 is a polypropylene homopolymer for fibers and general purpose designed for extrusion and injection molding. The base resin in this product meets the requirements of the FDA contained in the Code of Federal Regulations in 21 CFR 177.1520. Features: High rigidity Ease of processing High dimensional stability Typical Applications: Monofilament and multifilament Housewares Injection Caps and closures Cast film&&

About

Pro-fax 6331 Pro-fax 6331 general purpose polypropylene homopolymer is available in pellet form. This resin is typically used in injection molding applications. For regulatory compliance information see Pro-fax 6331 Product Stewardship Bulletin (PSB).&&Pro-fax 6331 Profax 6331 is a polypropylene homopolymer for fibers and general purpose designed for extrusion and injection molding. The base resin in this product meets the requirements of the FDA contained in the Code of Federal Regulations in 21 CFR 177.1520. Features: High rigidity Ease of processing High dimensional stability Typical Applications: Monofilament and multifilament Housewares Injection Caps and closures Cast film&&

Product Description
Supplier	LyondellBasell
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Good Rigidity,Excellent Processability,Good Dimensional Stability,Good liquidity,Food contact compliance,Homopolymer,Good coloring
Availabilitys	North America,Latin America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D792-A
Melt Flow Rate
230℃，2.16kg	12	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	34.0	MPa	ASTM D638
Tensile strain
yield	11	%	ASTM D638
Bending modulus	1350	MPa	ASTM D790B

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	32	J/m	ASTM D256-A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	95.0	℃	ASTM D648

Notes
1. Typical properties: these are not to be construed as specifications.
2. 2.0 in/min
3. 0.051 in/min
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.