| About |
|---|
| Badaflex® TPU 80A 8018 is a Thermoplastic Polyurethane Elastomer material. It is available in Europe for injection molding.&& |
| Product Description | |
|---|---|
| Generic | TPU |
| Material Status | Commercial: Negative |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | DIN 53479 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| MD | 45.0 | MPa | DIN 53504 |
| Tensile strain | |||
| MD, fracture | 620 | % | DIN 53504 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | |||
| MD | 60 | kN/m | DIN 53515 |
| Compression deformation | DIN 53515 | ||
| 23℃，72 hr | 25 | % | DIN 53515 |
| 70℃，24 hr | 40 | % | DIN 53515 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 80 | DIN 53505 | |
| Wear amount | 30.0 | mm³ | DIN 53516 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 90 | °C | |
| Drying time | 3.0 | hr | |
| Processing (melt) temperature | 175 to 200 | °C | |
| Mold temperature | 30 to 60 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |