| About |
|---|
| ADMER® AT2146E is an maleic anhydride grafted PE- based adhesive designed for double- and triple- bubble process. It shows high adhesion to PE, PA, EVOH, PP, PC and PET.&& |
| Product Description | |
|---|---|
| Supplier | Mitsui |
| Generic | PE |
| Material Status | Commercial: Active |
| Features | Food contact compliance,Good bond |
| Availabilitys | Africa & Middle East ,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.3 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Notched impact strength of cantilever beam | 无断裂 | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 72.0 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 39 | ASTM D2240 | |
| tensile strength | |||
| fracture | 28.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 500 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 180 to 200 | °C | |
| Barrel 2 zone temperature | 180 to 200 | °C | |
| Barrel 3 zone temperature | 200 to 230 | °C | |
| Barrel 4 zone temperature | 200 to 230 | °C | |
| Melt temperature | 200 to 230 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |