| About |
|---|
| Thermoplastic Elastomer based on SEBS [TPE-SEBS-FR(17)] Injection moulding grade Styrene-Ethylen-/Butadien-Styrene Copolymer; UL listed halogenated flame retardant V0 according to RoHS standard&& |
| Product Description | |
|---|---|
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Flame Characteristics,Copolymer,Bromination |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.26 | g/cm³ | DIN 53479 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | |||
| MD | 22 | kN/m | DIN 53515 |
| Compression deformation | |||
| 23℃，72 hr | 32 | % | DIN 53515 |
| 70℃，24 hr | 57 | % | ISO 815 |
| 100℃，24 hr | 79 | % | ISO 815 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 0.40 mm | V-0 | ||
| 3.00 mm | V-0 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Overmold Bonding | Polypropylene (PP) |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 80 | DIN 53505 | |
| tensile strength | |||
| flow | 12.0 | MPa | DIN 53504 |
| Tensile strain | |||
| Flow rate, fracture | 490 | % | |
| TD, fracture | 510 | % |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 180 to 220 | °C | |
| Mold temperature | 30 to 50 | °C | |
| Injection speed | 快速 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |