Rigidex® P 450-HP90

About
Rigidex® P 450-HP90 is a nucleated and antistatic high flow high impact copolymer specifically designed for very fast cycling, thin walled injection moulding applications. The Rigidex® P series of polypropylene resins are manufactured using the latest catalyst/process developments on Innovene P gas phase technology. As a result, they offer an industry leading balance between fluidity, rigidity and impact resistance. New nucleating technology leads to higher isotropy and subsequently lower warpage of the final objects. Applications: Very Thin Walled Technical Mouldings Yellow fat containers Housewares Benefits and Features: Very good impact, even below 0°C Low warpage Very high flowability Very short cycle time Antistatic&&

About

Rigidex® P 450-HP90 is a nucleated and antistatic high flow high impact copolymer specifically designed for very fast cycling, thin walled injection moulding applications. The Rigidex® P series of polypropylene resins are manufactured using the latest catalyst/process developments on Innovene P gas phase technology. As a result, they offer an industry leading balance between fluidity, rigidity and impact resistance. New nucleating technology leads to higher isotropy and subsequently lower warpage of the final objects. Applications: Very Thin Walled Technical Mouldings Yellow fat containers Housewares Benefits and Features: Very good impact, even below 0°C Low warpage Very high flowability Very short cycle time Antistatic&&

Product Description
Supplier	INEOS
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Low warping,High impact resistance,High liquidity,Nucleation,Quick molding cycle,Antistatic property,low-temperature impact resistance,Impact copolymer
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Melt Flow Rate
230℃，2.16kg	90	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Bending modulus
23℃	1350	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch			ISO 180/1A
-20℃	4.2	kJ/m²	ISO 180-1A
23℃	5.8	kJ/m²	ISO 180-1A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	104	℃	ISO 75-2/B

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.