| About |
|---|
| Product Description | |
|---|---|
| Generic | PA+PPO(PPE) |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| other | Nominal value | Unit | Test method |
| UL flame retardant rating | |||
| 1.6mm | HB | UL94 | |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | Ω | ASTM D25 | |
| Volume resistivity | Ω.m | ASTM D257 | |
| Dielectric constant | |||
| 1MHz | ASTM D150 | ||
| loss factor | |||
| 1MHz | ASTM D150 | ||
| Dielectric strength | |||
| 2.0 mm thick | MV/m | ASTM D257 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 55 | MPa | ASTM D638 |
| elongation at break | % | ASTM D638 | |
| bending strength | 80 | MPa | ASTM D790 |
| Bending modulus | 2000 | MPa | ASTM D790 |
| Charpy impact strength | |||
| Gap, 23 ℃ | 20 | KJ/m² | ASTM D256 |
| Non notch, 23 ℃ | KJ/m² | ASTM D256 |
| Hot deformation temperature | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.82MPa | ℃ | ASTM D648 | |
| 0.45MPa | 180 | ℃ | ASTM D648 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| proportion | 1.09 | g/cm³ | ASTM D792 |
| Water absorption rate | 3.5 | % | ASTM D570 |
| Forming shrinkage rate | 1.5-1.9 | % | ASTM D955 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |