| About |
|---|
| Petrothene GA808091 is a broad molecular weight, linear low density polyethylene resin selected by customers for use as a base resin in wire and cable jacketing. An antioxidant package is added to ensure thermal stability during processing. Petrothene GA808091 meets the requirements of the following: ASTM D 1248, Type I, Class A, Category 4, Grade E5; Federal LP390C, Type II, Class L, Category 4, Grade 4.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good flexibility,Low or no water absorption,Low Viscosity,noise reduction,Insulation,Fast Cure |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.920 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.75 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 10% non-ionic detergent | > 1000 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 57 | ASTM D2240 | |
| tensile strength | |||
| fracture | 15.9 | MPa | ASTM D638 |
| yield | 12.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 650 | % | ASTM D638 |
| Bending modulus | |||
| 1% secant | 345 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -76.0 | ℃ | ASTM D746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric constant | |||
| 1 MHz | 2.29 | ASTM D1531 | |
| Dissipation factor | |||
| 1 MHz | 6.0E-5 | ASTM D1531 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 154 to 163 | °C | |
| Barrel 2 zone temperature | 177 to 193 | °C | |
| Barrel 3 zone temperature | 193 to 210 | °C | |
| Barrel 4 zone temperature | 204 to 218 | °C | |
| Connector temperature | 204 to 218 | °C | |
| Nozzle temperature | 204 to 218 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |