| About |
|---|
| MICROTHENE MP564189 exhibits good stiffness and low temperature toughness. Typical applications include trash cans, industrial containers, housewares and toys. MP564189 is 16 mesh powder and is also available in pellet form Petrothene GA564189. MP564189 meets the requirements of the Food and Drug Administration 21 CFR 177.1520. This regulation allows the use of this olefin polymer in” …articles or components or articles intended for use in contact with food.” Specific limitations or conditions of use may apply.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Food contact compliance,Low temperature toughness |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.924 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 20 | g/10min | ASTM D1238 |
| Spiral flow length | 32.1 | cm | Internal Method |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 45.0 | ℃ | ASTM D648 |
| Embrittlement temperature | < -76.1 | ℃ | ASTM D746 |
| Vicat Softening Temp | 91.0 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 57 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| yield | 14.0 | MPa | ASTM D638 |
| fracture | 8.00 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 12 | % | ASTM D638 |
| Bending modulus | ASTM D790 | ||
| 1% secant | 440 | MPa | ASTM D790 |
| 2% secant | 380 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 177 | °C | |
| Barrel 2 zone temperature | 190 | °C | |
| Barrel 3 zone temperature | 204 | °C | |
| Barrel 4 zone temperature | 204 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Melt Temperature: 440°F, Injection Pressure: 1.00E+3 psi |
| 3. 0.625 in |
| 4. 20 in/min |
| 5. 0.50 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |