| About |
|---|
| DAI-EL® T-530 DAI-EL® T-530 is a thermoplastic elastomer that has rubber-like elasticity yet processes like a thermoplastic. DAI-EL® T-530 is transparent and low in extractibles. It is USP Class VI certified. DAI-EL® T-530 exhibits excellent physical properties and chemical resistance without crosslinking, but where sealing ability is required it may be crosslinked by e-beam radiation.&&DAI-EL® T-530 DAI-EL thermoplastic T-530 is a thermoplastic fluoroelastomer, which provides excellent transparency and cleanliness in particular.&& |
| Product Description | |
|---|---|
| Supplier | Daikin Fluorochemicals |
| Generic | 氟橡胶 |
| Material Status | Commercial: Active |
| Features | Good Clarity,Low extract,Solvent resistance |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.89 | g/cm³ | |
| Melt Flow Rate | |||
| 230℃，2.16kg | 22 | g/10min | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 11.0 | MPa | |
| Tensile strain | |||
| fracture | 650 | % | |
| tear strength | 27.0 | kN/m | |
| Compression deformation | |||
| 50℃，24 hr | 11 | % | |
| Resilience | 10 | % |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 220 | ℃ | |
| specific heat | 1260 | J/kg/℃ | |
| Thermal conductivity coefficient | 0.15 | W/m/K |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 5.0E+13 | ohms·cm | |
| Dielectric strength | 14 | kV/mm | |
| Dielectric constant | |||
| 1 kHz | 6.60 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Gehman Torsion Test（T50） | -9 | ℃ | |
| Pyrolysis Initiation Temperature | 380 | ℃ |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 67 | Internal Method | |
| friction coefficient | 0.60 | ||
| Taber abraser | |||
| 1000 cycles, CS-17 wheel | 2.00 | mg | |
| 1000 cycles, H-22 wheels | 10.0 | mg |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 100 KGy Radiation |
| 4. 150 KGy Radiation |
| 5. 10 KGy Radiation |
| 6. 30 KGy Radiation |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |