| About |
|---|
| Features and Uses: Medical and Food Grade Flexible Film and Sheet Low Gels and Contamination Medical and Food Grade Tubing and Molded Devices Uniform Plasticizer Absorption Wire and Cable Insulation Excellent Color and Clarity&& |
| Product Description | |
|---|---|
| Generic | PVC homopolymer |
| Material Status | Commercial: Active |
| Features | Good Clarity,High purity,Low speed solidification point,Homopolymer,Good coloring |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Apparent density | 0.48 to 0.56 | g/cm³ | Internal Method |
| K-Value | 70.0 to 72.0 | ||
| pollutant | < 16 | number/kg | Internal Method |
| Intrinsic viscosity | 1.1 | dl/g | Internal Method |
| Particle size | Malvern | ||
| % Retained on Pan | < 3.00 | % | Malvern |
| % Retained on 200 mesh | < 18.0 | % | Malvern |
| % Retained on 40 mesh | < 0.200 | % | Malvern |
| % Retained on 60 mesh | < 2.00 | % | Malvern |
| Gel content | |||
| 4’ mill results | < 10.0 | Internal Method | |
| Relative viscosity | 2.42 to 2.50 | ||
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| CAS Number | 9002-86-2 | ||
| Powder mixing time | 4.2 to 5.8 | min | Internal Method |
| Residual monomer | < 1 | ppm | Internal Method |
| volatility | < 0.30 | % | Internal Method |
| porosity | 0.300 to 0.400 | cm³/g | Internal Method |
| Flow time | < 12.0 | sec | Internal Method |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |