| About |
|---|
| INSULGEL 50 FC Black is a room temperature curing epoxy gel. It is low in viscosity and does not normally require vacuum de-gassing to assure bubble-free castings.&& |
| Product Description | |
|---|---|
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Low Viscosity |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| Electrical performance | Nominal value | Unit | Test method |
| Volume resistivity | 1.0E+14 | ohms·cm | ASTM D257 |
| Dielectric strength | 17 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 1 kHz | 3.50 | ASTM D150 | |
| Dissipation factor | |||
| 1 kHz | 0.020 | ASTM D150 | |
| Uncured Properties | Nominal value | Unit | Test method |
|---|---|---|---|
| colour | |||
| — | Amber | ||
| — | Black | ||
| Density | |||
| — | 0.948 | g/cm³ | |
| — | 1.05 | g/cm³ | |
| viscosity | ASTM D2393 | ||
| — | 0.30 | Pa·s | ASTM D2393 |
| — | 0.50 | Pa·s | ASTM D2393 |
| — | 0.55 | Pa·s | ASTM D2393 |
| Curing time | |||
| 25℃ | 24 | hr | |
| storage stability | |||
| 25 ℃ | 10 | min |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 50 | ASTM D2240 | |
| tensile strength | 4.14 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 150 | % | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear coefficient of thermal expansion | |||
| MD | 4.5E-5 | 1/℃ | |
| Thermal conductivity coefficient | 0.23 | W/m/K | |
| Operating temperature | 105 | ℃ | |
| Thermosetting components | |||
| Component A | 按重量计算的混合比: 100 | ||
| Component B | 按重量计算的混合比: 25 | ||
| Storage period | |||
| 25℃ | 52 | wk |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Part B |
| 3. Part A |
| 4. Mixed |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |