| About |
|---|
| Features and Benefits Composition: di-polymer of vinylidene fluoride and hexafluoropropylene Ultra low viscosity gumstock without incorporated curatives Process targets: injection and transfer molding, extrusion, calendering and coatings Viscosity modifier Greater flow and filler loadings compared to conventional high viscosity 66% fluoropolymers FC 2211 is amine or bisphenol curable&& |
| Product Description | |
|---|---|
| Generic | 氟橡胶 |
| Material Status | Commercial: Active |
| Features | Low Viscosity |
| Availabilitys | North America,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.80 | g/cm³ | Internal Method |
| Mooney viscosity | |||
| ML 1+10，100℃ | 20 | MU | Internal Method |
| Fluorine content | 66 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 75 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 12.9 | MPa | ASTM D412A |
| 100% strain | 4.10 | MPa | ASTM D412A |
| Tensile strain | |||
| fracture | 180 | % | ASTM D412A |
| Compression deformation | |||
| 200℃，70 hr | 17 | % | ASTM D1414 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |