| About |
|---|
| Product Description | |
|---|---|
| Supplier | Evonik |
| Material Status | Commercial: Active |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile modulus | 3700 | MPa | ISO 527 |
| Yield stress | 100 | MPa | ISO 527 |
| Yield strain | 5 | % | ISO 527 |
| The nominal strain at fracture, ε TB | 40 | % | ISO 527 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | |||
| 10N，50K/h | 335 | °C | ISO 306 |
| 50 N，50 K/h | 310 | °C | ISO 306 |
| Linear coefficient of thermal expansion | |||
| parallel | 60 | E-6/K | ISO 11359-1/-2 |
| physical property | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1300 | kg/m³ | ISO 1183 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Test thickness | 3.2 | mm | – |
| Electrical characteristics | Nominal value | Unit | Test method |
|---|---|---|---|
| Relative dielectric constant, 1MHz | 2.8 | – | IEC 62631-2-1 |
| Volume resistivity, ρ V | >1E13 | Ohm*m | IEC 62631-3-1 |
| CTI, test solution A, 50 drop value | 200 | – | IEC 60112 |
| Rheological properties | Nominal value | Unit | Test method |
|---|---|---|---|
| Melt volume flow rate | 70 | cm³/10min | ISO 1133 |
| temperature | 380 | °C | – |
| load | 5 | kg | – |
| Forming shrinkage | |||
| parallel | 1.1 | % | ISO 294-4, 2577 |
| normal | 1.1 | % | ISO 294-4, 2577 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy impact strength | |||
| 23°C | N | kJ/m² | ISO 179/1eU |
| -30°C | N | kJ/m² | ISO 179/1eU |
| Charpy Notched Impact Strength | |||
| 23°C | 6 | kJ/m² | ISO 179/1eA |
| -30°C | 6 | kJ/m² | ISO 179/1eA |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |