ENSOFT SD-300-70A

About
This polyolefin based thermoplastic elastomer (SEBS) compound is unfilled, high performance and completely recyclable. ENSOFT® series can be processed with conventional thermoplastics machinery Additive Packages : T / Heat and UV stabilizer Key Features : Translucent Excellent ozone, UV and weathering resistance Rubberlike elasticity in a wide temperature range Low compression set Easy colorability with proper MB (PE, PP, etc. based) Process Method : Extrusion, coextrusion, sheet extrusion Uses : Extruded parts (seals, tubes, profiles, hoses, etc.) for automotive, construction, home appliances, furniture&&

About

This polyolefin based thermoplastic elastomer (SEBS) compound is unfilled, high performance and completely recyclable. ENSOFT® series can be processed with conventional thermoplastics machinery Additive Packages : T / Heat and UV stabilizer Key Features : Translucent Excellent ozone, UV and weathering resistance Rubberlike elasticity in a wide temperature range Low compression set Easy colorability with proper MB (PE, PP, etc. based) Process Method : Extrusion, coextrusion, sheet extrusion Uses : Extruded parts (seals, tubes, profiles, hoses, etc.) for automotive, construction, home appliances, furniture&&

Product Description
Generic	TPE
Material Status	Commercial: Active
Features	Weather resistance is good,Good Dimensional Stability,High elastic,Renewable resources,Ozone resistance,Solvent resistance,Heat Stabilized,Good coloring
Availabilitys	North America,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ISO 1183/A

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shore A, 3 seconds	70		ISO 868

elastic body	Nominal value	Unit	Test method
tensile strength
fracture	13.0	MPa	ISO 37
100% strain	2.90	MPa
300% strain	4.20	MPa
Tensile strain
fracture	> 800	%	ISO 37
tear strength
TD	45	kN/m	ISO 34-1
Compression deformation
23℃，72 hr	21	%
70℃，22 hr	45	%

THERMAL	Nominal value	Unit
Embrittlement temperature	-55.0	℃
Operating temperature
Dynamic	90	℃
Static	135	℃

Process Conditions
Extrusion	Nominal value	Unit	Test method
Barrel 1 zone temperature	170 to 190	°C
Barrel 3 zone temperature	180 to 195	°C
Barrel 5 zone temperature	195 to 205	°C
Connector temperature	200 to 210	°C
Nozzle temperature	200 to 220	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.