| About |
|---|
| RTP 1500-30D is a Thermoplastic Elastomer, Ether-Ester (TEEE) material. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America for injection molding.&& |
| Product Description | |
|---|---|
| Generic | TEEE |
| Material Status | Commercial: Negative |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.07 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD：3.2 mm | 0.50 to 2.0 | % | ASTM D955 |
| water content | < 0.10 | % | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 3.2mm | 无断裂 | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 30 | ASTM D2240 | |
| tensile strength | 24.1 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 600 | % | ASTM D638 |
| Bending modulus | 27.6 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 99 | °C | |
| Drying time | 2.0 to 3.0 | hr | |
| Processing (melt) temperature | 191 to 210 | °C | |
| Mold temperature | 21 to 49 | °C | |
| Injection pressure | 68.9 to 103 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |