| About |
|---|
| Kraton G1750 M is a clear, multi-arm polymer based on ethylene/propylene. It is supplied from North America in the physical form identified below. G1750 M – supplied in a bale Kraton G1750 M is used as a modifier of polymers. It is also suitable as an ingredient in formulating compounds for footwear applications and may be used in formulating adhesives, sealants and coatings.&& |
| Product Description | |
|---|---|
| Generic | EPM |
| Material Status | Commercial: Active |
| Features | Inoxidizability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.860 | g/cm³ | ASTM D4025 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 8.0 | g/10min | Internal Method |
| Antioxidant Additive | 0.030 to 0.20 | % | Internal Method |
| Volatiles | < 1.0 | % | Internal Method |
| viscosity | |||
| 100℃ | 11.8 to 14.1 | cSt | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 30 seconds | 11 | Internal Method |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | < 0.345 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 100 | % | ASTM D412 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Styrene/Rubber ratio | 0/100 | % | Internal Method |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Kinematic Viscosity, 1.7%w (ENJ404@100C) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |