| About |
|---|
| DESCRIPTION: EPDM based compound FEATURES: medium hard, dimension stability APPLICATIONS: Injection Molding&& |
| Product Description | |
|---|---|
| Generic | EPDM+SEBS |
| Material Status | Commercial: Active |
| Features | Good Dimensional Stability,Terpolymer |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.948 to 0.998 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.50 to 1.0 | g/10min | ASTM D1238 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | > 3.45 | MPa | ASTM D412 |
| 300% strain | > 2.07 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | > 900 | % | ASTM D412 |
| Compression deformation | |||
| 70℃，22 hr | 45 to 50 | % | ASTM D395B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 48 to 52 | ASTM D2240 | |
| DIN Abrasion | < 250.0 | mg | DIN 53516 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 165 to 190 | °C | |
| Barrel middle temperature | 165 to 190 | °C | |
| Barrel front temperature | 165 to 190 | °C | |
| Injection pressure | 35.0 to 150 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 20 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |