| About |
|---|
| Kraton D1102 J is a clear, linear block copolymer based on styrene and butadiene with bound styrene of 30% mass. It is supplied from Japan in the physical form(s) outlined in the following grade nomenclature D1102 JS – supplied as porous pellets dusted with amorphous silica D1102 JSZ – supplied as porous pellets dusted with amorphous silica Kraton D1102 J is used as an ingredient in formulating adhesives, sealants, and coatings. It may also find use as a modifier of bitumen and polymers.&& |
| Product Description | |
|---|---|
| Generic | SBC |
| Material Status | Commercial: Active |
| Features | Block Copolymer |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.940 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 6.0 | g/10min | ISO 1133 |
| Combined with styrene | 30.0 | % | |
| Ash Content | < 1.0 | % | ISO 247 |
| Volatiles | < 1.0 | % | Internal Method |
| Solution viscosity | |||
| 25% toluene solution, 25 ℃ | 0.80 to 1.6 | Pa·s | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 30 seconds | 70 | ISO 7619 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 33.0 | MPa | ISO 37 |
| 300% strain | 2.90 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 880 | % | ISO 37 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 25%w toluene solution at 25°C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |