| About |
|---|
| Kraton D1160 B is a clear linear triblock copolymer based on styrene and isoprene with bound styrene of 18.5% mass. It is supplied from South America in the physical form identified below: Kraton D1160 BT – supplied as a porous pellet dusted with talc Kraton D1160 BT is used in formulating adhesives, in particular hot melt pressure sensitive adhesives.&& |
| Product Description | |
|---|---|
| Generic | SIS |
| Material Status | Commercial: Active |
| Features | Block Copolymer,Inoxidizability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.920 | g/cm³ | ISO 2781 |
| Apparent density | 0.35 | g/cm³ | ASTM D1895 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 5.0 to 13 | g/10min | ISO 1133 |
| Solution viscosity | 700 to 1100 | mPa·s | Internal Method |
| Antioxidant Additive | > 0.080 | % | Internal Method |
| Extractables | < 1.0 | % | Internal Method |
| Polystyrene content | 17 to 21 | % | Internal Method |
| molecular weight | 168000 to 188000 | g/mol | Internal Method |
| Ash Content | |||
| Product form “BT” | < 0.50 | % | ISO 247-B |
| Volatiles | < 0.30 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 30 seconds, molded | 48 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 32.0 | MPa | ISO 37 |
| 300% strain | 1.90 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 1300 | % | ISO 37 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |