| About |
|---|
| Hexene Copolymer Linear Medium Density Polyethylene for rotational molding. This resin is fully UV8 stabilized. Available as natural and several colors powder compounds. Applications: High quality Polyethylene is specifically designed for applications requiring excellent processability and aesthetics combined with low warpage and good mechanical properties. It is recommended for intermediate bulk containers, toys, marine parts and indoor consumer articles. Excellent impact strength, stress crack resistance (ESCR) and procesability. Natural Resin, which is used as a carrier in color compounds meets all requirements of US food and drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles intended for direct food contact.&& |
| Product Description | |
|---|---|
| Generic | LMDPE |
| Material Status | Commercial: Negative |
| Features | Weather resistance is good,Low warping,Excellent Processability,High impact resistance,High liquidity,Food contact compliance,Copolymer,Hexene copolymers,High ESCR |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.935 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 7.0 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | ASTM D1693 | ||
| 10% non-ionic detergent | > 200 | hr | ASTM D1693 |
| 100% non-ionic detergent | > 1000 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D638 | ||
| yield | 18.0 | MPa | ASTM D638 |
| fracture | 20.7 | MPa | ASTM D638 |
| Tensile strain | ASTM D638 | ||
| yield | 13 | % | ASTM D638 |
| fracture | > 800 | % | ASTM D638 |
| Bending modulus | |||
| 1% secant | 655 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Low temperature shock | |||
| -40℃，3.18 mm | 61.0 | J | ARM |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 60.0 | ℃ | ASTM D648 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |