Mafill® CR CM 6144

About
PP Copolymer, Black, MFI 12, 10% mineral filled, industrial quality grade with excellent characterisitcs, injection moudling&&

Product Description
Generic	PP copolymer
Material Status	Commercial: Active
Features	Copolymer
Availabilitys	Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.950	g/cm³	ISO 1183
Melt Flow Rate
230℃，2.16kg	15	g/10min	ISO 1133
Ash Content	10	%	ISO 3451

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	1100	MPa	ISO 527-2
tensile strength
yield	24.0	MPa	ISO 527-2
Bending modulus	950	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch			ISO 180/1A
-20℃	2.0	kJ/m²	ISO 180-1A
23℃	8.0	kJ/m²	ISO 180-1A

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.