| About |
|---|
| Dynaprene VE5073A is an unreinforced TPE product for injection moulding in natural colour for Food and Drug Approval (FDA) applications&& |
| Product Description | |
|---|---|
| Supplier | Nantex |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good surface appearance,High Heat Resistance,Moisture resistance,Good wear resistance,Solvent resistance,Resistance to detergents,HB |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 5 seconds | 73 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile permanent deformation | |||
| 100% strain | 13 | % | ASTM D412 |
| tensile strength | |||
| TD, yield | 7.57 | MPa | ASTM D412 |
| 100% strain | 2.89 | MPa | ASTM D412 |
| Tensile strain | |||
| TD, fracture | 460 | % | ASTM D412 |
| tear strength | |||
| 23℃ | 33.3 | kN/m | ASTM D624 |
| Compression deformation | |||
| 100℃，22 hr | 37 | % | ASTM D395B |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Quality change rate | |||
| 121 ℃, 24 hours, in IRM 903 oil | 77 | % | ASTM D471 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -60.0 | ℃ | ASTM D746 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 0.75 mm | HB | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 180 to 280 | °C | |
| Barrel middle temperature | 180 to 280 | °C | |
| Barrel front temperature | 180 to 280 | °C | |
| Nozzle temperature | 210 to 220 | °C | |
| Processing (melt) temperature | 180 to 280 | °C | |
| Mold temperature | 10 to 70 | °C | |
| Injection pressure | 50.0 to 120 | MPa | |
| Hold pressure | 30.0 to 80.0 | MPa | |
| Back pressure | 0.00 to 0.300 | MPa | |
| Screw speed | 60 to 120 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |