| About |
|---|
| F103 is a Polypropylene Homopolymer, produced by the latest generation Spheripol Technology. This is an Extrusion grade primarily suitable for Monolayer or Coextruded Biaxially Oriented Polypropylene films (BOPP). F103 is designed to provide a very stable extrusion on stenter lines & to give low water carryover, excellent thickness control & increased drawability. BOPP films produced from F103 possess excellent Clarity, Gloss, Mechanical Strengths, high Impact & Puncture Resistance & barrier to Moisture, Aroma, Fats & Oils. Product produced from F103 is suitable for Food Contact application.&& |
| Product Description | |
|---|---|
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Clarity,Good surface appearance,High impact resistance,Good dissection,Retention of aroma ,Food contact compliance,Moisture resistance,Grease resistance,Block resin,Puncture Resistant,Low water portability,Homopolymer |
| Availabilitys | Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 3.3 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, injection molding | 34.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, injection molding | 10 | % | ASTM D638 |
| Bending modulus | |||
| injection molding | 1450 | MPa | ASTM D790-A |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 40 | J/m | ASTM D256-A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 95.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 152 | ℃ | ASTM D1525 5 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 230 to 280 | °C | |
| Barrel 2 zone temperature | 230 to 280 | °C | |
| Barrel 3 zone temperature | 230 to 280 | °C | |
| Barrel 4 zone temperature | 230 to 280 | °C | |
| Barrel 5 zone temperature | 230 to 280 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. Type I, 2.0 in/min |
| 4. with Extensometer |
| 5. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |