Grivory® HT XE 10811 NATURAL

About
Grivory HT XE 10811 Natural is a 40 wt.-% glass fibre reinforced engineering thermoplastic material based on a semi-crystalline, partially aromatic copolyamide. Grivory HT XE 10811 Natural is an injection moulding material. Acc. to ISO: PA 6T/6I Acc. to ASTM: PPA, polyphthalamide The main distinguishing feature of Grivory HT XE 10811 Natural, when compared to other polyamides, is its good performance at high temperatures. Particular properties are: chemical resistance optimised hydrolysis resistance creep resistance mechanical properties at high temperatures Grivory HT XE 10811 Natural is suitable for all engineering thermoplastic applications with the requirement of approvals in contact with food and/or drinking water in combination with high hydrolysis resistance and creep resistance.&&

About

Grivory HT XE 10811 Natural is a 40 wt.-% glass fibre reinforced engineering thermoplastic material based on a semi-crystalline, partially aromatic copolyamide. Grivory HT XE 10811 Natural is an injection moulding material. Acc. to ISO: PA 6T/6I Acc. to ASTM: PPA, polyphthalamide The main distinguishing feature of Grivory HT XE 10811 Natural, when compared to other polyamides, is its good performance at high temperatures. Particular properties are: chemical resistance optimised hydrolysis resistance creep resistance mechanical properties at high temperatures Grivory HT XE 10811 Natural is suitable for all engineering thermoplastic applications with the requirement of approvals in contact with food and/or drinking water in combination with high hydrolysis resistance and creep resistance.&&

Product Description
Supplier	EMS-GRIVORY
Generic	PA 6I/6T
Material Status	Commercial: Negative
Features	Good flexibility,Hydrolysis stability,Aromatic,Food contact compliance,High Heat Resistance,Hypocrystalline,Solvent resistance
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature
Hot air dryer	< 80	°C
Vacuum dryer	< 100	°C
Drying time
Hot air dryer	4.0 to 12	hr
Vacuum dryer	4.0 to 12	hr
Recommended maximum moisture content	0.10	%
Barrel rear temperature	330 to 340	°C
Barrel middle temperature	330 to 345	°C
Barrel front temperature	330 to 345	°C
Nozzle temperature	330 to 340	°C
Processing (melt) temperature	340	°C

Notes
1. Typical properties: these are not to be construed as specifications.
2. Long Term
3. Short Term
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.