| About |
|---|
| ARCEL® LD (2.50 pcf) is a Polystyrene + PE (PS+PE) material. It is available in North America for foam processing.&& |
| Product Description | |
|---|---|
| Generic | PS+PE |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Process Methods | Foam treatment |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.0400 | g/cm³ | ASTM D3575 |
| VOC Content | |||
| Pentane | 7.5 | % | |
| Plasticizer | 0.30 | % | |
| Particle size | |||
| 98% | 0.900 to 2.00 | mm | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 0.576 | MPa | ASTM D3575 |
| bending strength | ASTM C203 | ||
| 5% strain | 0.586 | MPa | ASTM C203 |
| — | 0.628 | MPa | ASTM C203 |
| compressive strength | ASTM D3575 | ||
| 10% strain | 0.268 | MPa | ASTM D3575 |
| 25% strain | 0.309 | MPa | ASTM D3575 |
| 50% strain | 0.385 | MPa | ASTM D3575 |
| 75% strain | 0.801 | MPa | ASTM D3575 |
| Bending strain | 9.2 | % | ASTM C203 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Burning rate | 70 | mm/min | FMVSS 302 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Puncture | 344 | N | ASTM D3763 |
| tear strength | |||
| at Maximum Load | 3.2 | kN/m | ASTM D3575 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |