TEREZ XG B 7006

About
Low viscosity polyamide 6 with 50% long glass fiber reinforcement. Granule length 10 mm til 14 mm. Attention! Injection molding screw head height, or screw feed and granule length,must be coordinated with each other. For parts with high impact stress and stiffness.&&

Product Description
Supplier	TER
Generic	PA6
Material Status	Commercial: Active
Features	Good Rigidity,High impact resistance,Low Viscosity
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.56	g/cm³
Water absorption rate
23℃，24hr	4.5	%
Equilibrium, 23 ℃, 50% RH	1.4	%

MECHANICAL	Nominal value	Unit
Tensile modulus	16000	MPa
tensile strength
fracture	245	MPa
Tensile strain
fracture	2.0	%

IMPACT	Nominal value	Unit
Charpy Notched Impact Strength
-30℃	35	kJ/m²
23℃	35	kJ/m²
Charpy Unnotch Impact strength
-30℃	85	kJ/m²
23℃	95	kJ/m²

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	220	℃

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Flammability level
1.6 mm	HB

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.