| About |
|---|
| M3204RU and Marvel M30, M40 are linear-low density polyethylene (LLDPE) for rotational molding applications.M30 is a color compounded form. Provide an excellent impact property with a balancing of stiffness and processability. Both of them are suitable for rotational molding of container and general applications&& |
| Product Description | |
|---|---|
| Supplier | SCG |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good flexibility,Food contact compliance,Good color stability,Low density,low-temperature impact resistance |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.932 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 4.0 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 64.0 | ℃ | ASTM D648 |
| Embrittlement temperature | < -60.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 110 | ℃ | ASTM D1525 |
| Melting temperature | 125 | ℃ | ASTM D2117 |
| Crystallization point | 110 | ℃ | ASTM D2117 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 55 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| yield | 17.0 | MPa | ASTM D638 |
| fracture | 25.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 1000 | % | ASTM D638 |
| Bending modulus | 580 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |