| About |
|---|
| HD800-U is a narrow molecular weight distribution homopolymer that exhibits enhanced flow characteristics and good balance of stiffness and impact resistance. Typical applications for HD800-U include cases, tote bins, crates and trays and open-head pails. HD800-U contains UV stabilizer for use in applications with exposure to sunlight. HD800-U meets the requirements of the Food and Drug Administration, 21 CFR Section 177.1520. This regulation allows the use of this olefin polymer in “…articles or components of articles intended for use in contact with food.” Specific limitations may apply. Contact your Osterman sales representative for more information.&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Weather resistance is good,High impact resistance,Good liquidity,Food contact compliance,Weight distribution,High density,Homopolymer |
| Availabilitys | Africa & Middle East ,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 8.0 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 75 | J/m | ASTM D256 |
| Notched impact strength of cantilever beam | |||
| -18℃ | 无断裂 | ASTM D4812 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -76.0 | ℃ | ASTM D746 |
| Melting temperature | 133 | ℃ | ASTM D3418 |
| Crystallization peak temperature | |||
| DSC | 116 | ℃ | ASTM D3418 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 70 | ASTM D648 | |
| Tensile modulus | |||
| — | 1010 | MPa | |
| 1% secant | 845 | MPa | |
| tensile strength | |||
| yield | 29.3 | MPa | |
| fracture | 15.9 | MPa | |
| Tensile strain | |||
| fracture | 380 | % | ASTM D638 |
| Bending modulus | |||
| — | 1410 | MPa | |
| 1% secant | 1450 | MPa | |
| 2% secant | 1070 | MPa |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type I, 2.0 in/min |
| 3. 0.49 in/min |
| 4. F50 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |