| About |
|---|
| DESCRIPTION: Random copolymer for extrusion and injection blow molding. FEATURES: Produced without animal derived components. STERILIZATION: ETO and autoclave. APPLICATIONS: Nutritional drink bottles, pharmaceutical BFS, irrigation containers, medical device components.&& |
| Product Description | |
|---|---|
| Supplier | INVISTA |
| Generic | PP copolymer |
| Material Status | Commercial: Active |
| Features | Ethylene oxide disinfection,High pressure disinfection,Random copolymer,ADCF |
| Availabilitys | North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 2.0 | g/10min | ASTM D1238 | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 82.0 | ℃ | ASTM D648 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | 85 | R 级 | ASTM D785 |
| tensile strength | |||
| Yield, 23 ℃ | 27.5 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, 23 ℃ | 15 | % | ASTM D638 |
| Tensile modulus | |||
| 23℃ | 1103 | MPa | ASTM D638 |
| Bending modulus | |||
| 1% secant, 23 ℃ | 1000 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |