| About |
|---|
| PLASTRON™ PP-GF50-02 is a Polypropylene material filled with 50% glass fiber. It is available in Asia Pacific.&& |
| Product Description | |
|---|---|
| Supplier | Daicel |
| Generic | PP not specified |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.33 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 140 | MPa | ISO 527-2 |
| Bending modulus | 11500 | MPa | ISO 178 |
| bending strength | 210 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| 23℃ | 45 | kJ/m² | ISO 179/1eA |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 162 | ℃ | ISO 75-2/A |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 1.0 | hr | |
| Barrel rear temperature | 180 to 230 | °C | |
| Barrel middle temperature | 190 to 240 | °C | |
| Barrel front temperature | 200 to 250 | °C | |
| Nozzle temperature | 200 to 250 | °C | |
| Mold temperature | 30 to 80 | °C | |
| Back pressure | 5.00 to 10.0 | MPa | |
| Screw speed | 40 to 60 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |