IDI SMC S30 (Glass Content 25%)

About
PRODUCT SERIES: S30 SERIES SMC PRODUCT DESCRIPTION: LOW PROFILE AUTOMOTIVE GRADE Low shrink composite materials. Well suited for applications requiring shrink <0.1%.&&

Product Description
Generic	热固性聚酯
Material Status	Commercial: Active
Features	Low contractility
Availabilitys	North America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.75 to 1.95	g/cm³	ASTM D792
Shrinkage rate
MD	0.10	%	ASTM D955
Water absorption rate
23℃，24hr	0.20 to 0.30	%	ASTM D570

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	750	J/m	ASTM D256
Notched impact strength of cantilever beam	960	J/m	ASTM D4812

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	> 204	℃	ASTM D648

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Burning rate	17	mm/min	ASTM D635

MECHANICAL	Nominal value	Unit	Test method
Babbitt hardness	15 to 60		ASTM D2583
Tensile modulus	13800	MPa	ASTM D638
tensile strength	68.9	MPa	ASTM D638
Bending modulus	12400	MPa	ASTM D790
bending strength	172	MPa	ASTM D790
compressive strength	186	MPa	ASTM D695

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.