Starglas FF006

About
Starglas FF006 is a Glass Fiber Reinforced High Density Polyethylene Resin (also known as Starglas PE HE 30V)&&

Product Description
Generic	HDPE
Material Status	Commercial: Active
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.18	g/cm³	ISO 1183
Shrinkage rate
MD：4.0 mm	0.30 to 0.50	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	5800	MPa	ISO 527-1-2
tensile strength
yield	55.0	MPa	ISO 527-2
Tensile strain
fracture	3.0	%	ISO 527-2
Bending modulus	4500	MPa	ISO 178
bending strength	77.0	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	7.0	kJ/m²	ISO 180-1A
Notched impact strength of cantilever beam
23℃	35	kJ/m²	ISO 180/1U

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	70	°C
Drying time	2.0	hr
Barrel rear temperature	170 to 200	°C
Barrel middle temperature	170 to 200	°C
Barrel front temperature	170 to 200	°C
Processing (melt) temperature	190	°C
Mold temperature	40 to 55	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.