| About |
|---|
| Resinoid 1324 is a Phenolic product filled with glass fiber. It can be processed by compression molding, injection molding, or resin transfer molding and is available in North America. Applications of Resinoid 1324 include automotive and electrical/electronic applications. Characteristics include: Flame Rated Good Dimensional Stability Heat Resistant Impact Resistant&& |
| Product Description | |
|---|---|
| Generic | 酚醛树脂 |
| Material Status | Commercial: Active |
| Features | High impact resistance,Good Dimensional Stability,Heat Stabilized,V-0 |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.99 | g/cm³ | ASTM D792 |
| Shrinkage rate | 2.0 | ASTM D1895 | |
| Shrinkage rate | |||
| MD | 0.20 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 0.10 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 64 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 316 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD | 2.5E-5 | 1/℃ | ASTM D696 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 12 | kV/mm | ASTM D149 |
| Arc resistance | 190 | sec | ASTM D495 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | ASTM D785 | ||
| E-level | 100 | ASTM D785 | |
| M-level | 115 | ASTM D785 | |
| tensile strength | |||
| yield | 62.1 | MPa | ASTM D638 |
| Bending modulus | 19300 | MPa | ASTM D790 |
| bending strength | |||
| yield | 82.7 | MPa | ASTM D790 |
| compressive strength | 198 | MPa | ASTM D695 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 149 to 177 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |