| About |
|---|
| PLUSTEK PA103NT is Natural, Low Viscocity POLYAMIDE 66, Extrusion u0026amp; Injection Molding Applications |
| Product Description | |
|---|---|
| Supplier | Ram-On |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Low Viscosity |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.14 | g/cm³ | ISO 1183 |
| Shrinkage rate | |||
| MD：2.0 mm | 1.0 to 1.5 | % | Internal Method |
| Water absorption rate | |||
| Saturation, 23 ℃ | 9.0 | % | |
| Equilibrium, 23 ℃, 50% RH | 3.0 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 3000 | MPa | ISO 527-2/1A |
| Tensile stress | 80.0 | MPa | ISO 527-2/1A |
| Tensile strain | |||
| yield | 4.5 | % | |
| fracture | 23 | % |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 5.0 | kJ/m² | ISO 180 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| Temperature at the rear of the barrel | 265 to 280 | °C | |
| Temperature in the middle of the barrel | 270 to 300 | °C | |
| Front temperature of material barrel | 280 to 300 | °C | |
| Mold temperature | 70 to 120 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |