CABELEC® CA6115

About
CABELEC CA6115 conductive compound is made from conductive carbon black and glass fibre dispersed in a modified high density polyethylene resin. Its electrical and mechanical properties are not impacted by normal atmospheric conditions. Applications CABELEC CA6115 conductive compound is used for injection moulding applications. It is suitable for product handling applications where it is desirable to mitigate the hazard of electrostatic discharge, such as the handling and packaging of explosive powders and liquids, pigments or electronic components.&&

About

CABELEC CA6115 conductive compound is made from conductive carbon black and glass fibre dispersed in a modified high density polyethylene resin. Its electrical and mechanical properties are not impacted by normal atmospheric conditions. Applications CABELEC CA6115 conductive compound is used for injection moulding applications. It is suitable for product handling applications where it is desirable to mitigate the hazard of electrostatic discharge, such as the handling and packaging of explosive powders and liquids, pigments or electronic components.&&

Product Description
Generic	HDPE
Material Status	Commercial: Active
Features	Conductive,High density
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.22	g/cm³	Internal Method
Melt Flow Rate			ISO 1133
190℃，10.0kg	2.0	g/10min	ISO 1133
190℃，21.6kg	11	g/10min	ISO 1133
Shrinkage rate
MD	0.20 to 0.30	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shore D, 15 seconds	66		ASTM D2240
tensile strength
fracture	36.0	MPa	ISO 527-2
Tensile strain
fracture	5.0	%	ISO 527-2
Bending modulus	2960	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	15	kJ/m²	ISO 180

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	92.0	℃	ISO 75-2/A
Vicat Softening Temp	120	℃	ISO 306/A

Electrical performance	Nominal value	Unit	Test method
Surface resistivity	1.6E+2	ohms	Internal Method
Volume resistivity	28	ohms·cm	Internal Method

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	80	°C
Drying time	2.0 to 4.0	hr
Barrel rear temperature	220	°C
Barrel middle temperature	220	°C
Barrel front temperature	220	°C
Nozzle temperature	260	°C
Mold temperature	35 to 45	°C
Injection speed	Slow
Screw speed	50 to 60	rpm

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.