PBT 1210G6 - SOLIAO

About
30%玻纤增强，高强度及高抗热变形，电气性能佳。适用于汽车、电子、电器等产业精密注塑用，如日光灯基座、省电灯泡用灯座、汽车用之分电盘、汽车把手、灯座、风扇外壳、电器零件开关等。

Product Description
Supplier	Nan Ya
Generic	polybutylene terephthalate
Material Status	Commercial: Active
Availabilitys	Asia Pacific

Technical Data
Electrical performance	Nominal value	Unit	Test method
Arc resistance	100	sec	ASTM D495
Insulation failure strength (3.2mm)	22	Kv/mm	ASTM D149

MECHANICAL	Nominal value	Unit	Test method
tensile strength	130	Mpa	ASTM D638
Bending modulus	8000	Mpa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Notch impact strength (3.2mm)	88.2	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa	210	℃	ASTM D648

PHYSICAL	Nominal value	Unit	Test method
Shrinkage rate
3.0 mm	0.3~1.2	%	ASTM D955
Density	1.52	g/cm³	ASTM D792

Process Conditions
injection molding	Nominal value	Unit	Test method
Nozzle temperature	235	℃
Barrel temperature – front section	240	℃
Barrel temperature – middle section	240	℃
Barrel temperature – rear section	250	℃
Mold temperature	80	℃
Injection pressure	40~50	MPa
Screw speed	80	rpm
Injection speed	最大

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.