Arnite® A06 300

About
solef ® 6012 PVDF均聚物是一种高粘度PVDF树脂，通常采用挤塑或模压成型加工。&&

Product Description
Supplier	DSM
Generic	PET
Material Status	Commercial: Active
Features	High Viscosity,Homopolymer
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Extrusion

Technical Data
THERMAL	Nominal value	Unit	Test method
Melting temperature	255	℃	ISO 11357-3

Supplementary information	Nominal value	Unit	Test method
RSV	2.04		Internal Method

PHYSICAL	Nominal value	Unit	Test method
Density	1.40	g/cm³	ISO 1183
Water absorption rate
Saturation, 23 ℃	0.75	%	ISO 62
Equilibrium, 23 ℃, 50% RH	0.30	%	ISO 62
Melt thermal conductivity	0.24	W/m/K
Specific Heat Capacity of Melt	2050	J/kg/℃

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	100 to 120	°C
Drying time	3.0 to 12	hr
Barrel rear temperature	270 to 280	°C
Barrel middle temperature	270 to 290	°C
Barrel front temperature	270 to 290	°C
Nozzle temperature	270 to 290	°C
Processing (melt) temperature	270 to 290	°C
Mold temperature	130 to 140	°C
Injection speed	Moderate-Fast
Back pressure	3.00 to 10.0	MPa
Screw compression ratio	2.5:1.0

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.