ADMER™ AT2519E

About
ADMER™ AT2519E is a maleic anhydride grafted, co-PP-based grade designed for retort products. It shows high adhesion and good processability in co-extrusion coating application between PP and EVOH, PA, Aluminum or Paper.

Product Description
Supplier	Mitsui
Generic	MAH-g-PP增容剂
Material Status	Commercial: Active
Features	Excellent Processability,Food contact compliance,Good bond
Availabilitys	Africa & Middle East ,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.890	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	13	g/10min	ASTM D1238

IMPACT	Nominal value	Unit	Test method
Notched impact strength of cantilever beam	0.0760	kJ/m²	ASTM D256

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	122	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	60		ASTM D2240
Tensile strength
yield	20.0	MPa
fracture	24.0	MPa
Tensile strain
fracture	> 500	%	ASTM D638

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.