| About |
|---|
| Versaflex™ GP 2810-40N is an easy processing, general purpose TPE designed for a wide variety of applications, and may be appropriate where FDA and EU 10/2011 compliances are required. Non-Slip Grip Overmold Adhesion to Polypropylene Soft Touch, Rubbery Feel&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Negative |
| Features | Excellent Processability,Renewable resources,Good liquidity,Good coloring |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 3 seconds | 40 | DIN 53505 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | DIN 53504 | ||
| Fracture, 2 mm | 4.00 | MPa | DIN 53504 |
| 100% strain, 2 mm | 1.00 | MPa | DIN 53504 |
| 300% strain, 2 mm | 1.50 | MPa | DIN 53504 |
| Tensile strain | |||
| Fracture, 2 mm | 700 | % | DIN 53504 |
| tear strength | |||
| 2.00 mm | 17.0 | kN/m | ISO 34 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 26 | % | ISO 815 |
| 70℃，22 hr | 45 | % | ISO 815 |
| 100℃，22 hr | 67 | % | ISO 815 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 0.890 | g/cm³ | ISO 1183 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 3.0 | g/10min | ISO 1133 |
| 190℃，5.0kg | > 100 | g/10min | ISO 1133 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 5.90 | Pa·s | ISO 11443 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 160 to 188 | °C | |
| Barrel middle temperature | 177 to 193 | °C | |
| Barrel front temperature | 188 to 210 | °C | |
| Nozzle temperature | 188 to 216 | °C | |
| Mold temperature | 16 to 38 | °C | |
| Notes |
|---|
| 1. Product rating may be influenced by end product design and/or conditions of use. Please contact GLS Thermoplastic Elastomers for information addressing EU (EU, 10/2011) and FDA (21 CFR 177.1210 and 177.2600) compliance. |
| 2. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |