| About |
|---|
| AGILITY™ EC 7220 Performance LDPE is a high melt strength LDPE, designed for the foam industry. This resin enables the stable production of very low density foams. It can be used both in crosslinked and non-crosslinked products. Complies with: Europe Commission Regulation (EU) No 10/2011. U.S. FDA 21 CFR 177.1520(c)2.1. Consult the regulations for complete details.&& |
| Product Description | |
|---|---|
| Supplier | DOW |
| Generic | LDPE |
| Material Status | Commercial: Negative |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.5 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 90.0 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 52 | ASTM D2240 | |
| tensile strength | |||
| Fracture, molded | 13.7 | MPa | ISO 527-2 |
| Tensile strain | |||
| Fracture, molded | 540 | % | ISO 527-2 |
| Bending modulus | |||
| Compression Molding | 230 | MPa | ISO 178 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 108 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |