| About |
|---|
| Alkadyne HDF193B is a black high molecular weight bimodal PE100 High Density Polyethylene. It is a high performance resin for use in pressure pipes where service life to 100 years is required. Alkadyne HDF193B offers a balance of excellent processing characteristics along with outstanding toughness, chemical resistance and slow crack growth resistance. Alkadyne HDF193B will also provide excellent resistance to the effects of ultra-violet light exposure in outdoor applications due to well dispersed carbon black. Alkadyne HDF193B is suitable for extrusion into a full range of pipes, where High Density, PE 100 type resins are required. In particular, a broad processing window and good sag resistance enables the extrusion of larger bore, thick wall pipe. Alkadyne HDF193B is suitable for use in the transport of a wide range of fluids for industrial, rural and mining applications, including potable water. Suitability for use in any application should be determined by appropriate performance testing.&& |
| Product Description | |
|---|---|
| Supplier | Qenos |
| Generic | HMW-HDPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,High molecular weight,Ultra high toughness,High density,Solvent resistance,Bimodal molecular weight distribution,High ESCR |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.956 | g/cm³ | Internal Method |
| Melt Flow Rate | ASTM D1238 | ||
| 190℃，21.6kg | 8.9 | g/10min | ASTM D1238 |
| 190℃，5.0kg | 0.30 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 63 | ASTM D2240 | |
| Tensile modulus | |||
| 1.90 mm | 1300 | MPa | ASTM D638 |
| tensile strength | ASTM D638 | ||
| Yield, 1.90 mm | 26.0 | MPa | ASTM D638 |
| Fracture, 1.90 mm | 33.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 1.90 mm | 760 | % | ASTM D638 |
| Bending modulus | |||
| 1% secant | 1150 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type IV, 2.0 in/min |
| 3. 0.50 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |